Wade95

All the removal, sanding, painting and re-install was during my 5 week baby leave for the birth of Karina Christina. This is a few months after.



Round 2, cage install. It has since been cut out. got tired of the safety issues of my oldest and lifting Karina over the bar and wiggling around the Corbeau seats I have.



Doug Carty in Seminole did the cage,,,great work, great price. I highly reccomend him.

Wade95

Ok, doing this thread has me figuring out I am on round 4. This is the removal of engine again and welding in of plates and re-paint.

Wade95

QA1 coil overs (Thanks Andrew) and QA1 C/C plates installed

Wade95

My first attempt at body work/bondo wasn't to bad, but wasn't so good either. Wanna know what made me decide that? Seeing the work John did on his and Wendy's car.



Everything in the fender except for the main harness from computer.

Wade95

I then had the motor out for a third time due to an oil leak and decided to try nitrous. Upgraded to Cometics, but for some reason I had water leaking from both sides after I reinstalled the heads. Couldn't figure it out, but finally did.

Wade95

Well, got it running and was able to get it dyno'd and that's when it did the 308/310. Started running real funny and after the install of the HB, flywheel, and DS is when I got the vibration. Also tried the 30lb injectors to see if it would fix the 15:1 A/F ration,,no help. Turning up fuel press. just made it burn your eyeballs at idle and would surge real bad.

Out it comes again!!!! Sold all my EFI stuff for $700.

Wade95

Ok, ther ya have it. Damn money pit! Haaaaaaa. Look fwd. to the replies. Wade.

KAILUAZ

Its nice you have it all in one thread now, I was looking for your patch panels to see if you cut out the factory metal first... anyway get that sucker on the street!

Wade95

Nope, didnt cut out a big hole like everybody does.

Did take my K member n a arms to Anclote recycling. 75lbs!!!!

Tiffiny

looks awesome good luck

i like the carb