damn Frank, the car looks awesome. wish i had your skills

 

Good job man, nice and clean looking..

 

Thanks guys,

Today I welded in the fuel filter mounting brackets, drilled and welded studs in the fuel cell mounting tabs..... Then I was able trim and weld in the last 2 pieces of the trunk floor..... I also made and welded in a filler panel where the gas tank filler neck goes through the trunk floor..... I primmed the entire trunk floor so it wouldn't surface rust while the car is getting the cage installed.....
The car is now ready to go to NBS for the cage install this week.....
In the mean while I will get the cover for the bottom of the fuel cell made, and I also need to make 2 small filler panels for infront off and behind the cell, these will be made of aluminum and pop-rivited in for possible access purposes later.....

 

looks good Frank

 

Very professional looking, Im inspired!

I like the pre-planning and execution of the tabs for everything.

 

Damn..... /\+1

 

nice fab there

 

Fuckin' A Frank. Looks bad-ass man.

 

Thanks to all,


Well I dropped it off at NBS this morning to get the cage done..... and now I think I'm feeling ill, man I hate leaving my car in anyone elses care.....

 

I know how you feel,but you should sleep well if it's at NBS.