S14 a/c lines
SLIDING SIDEWALL
Thread Starter
Join Date: Jan 2007
Posts: 1,175
Likes: 0
Received 0 Likes
on
0 Posts
S14 a/c lines
I'm pretty sure Ive got everything i need for my a/c to work again. The brackets are en-route and then everything should go together. These are the only 2 lines i took off when i did my SR swap so everything should still be in the car. My question is, on one of the lines, there's only one hole for it to bolt up to the compressor and there are 2 holes on the compressor for bolts to go into. The lines are actually from my car, so i know there correct. It's an S14 KA compressor although im not sure on the year since it didn't come off my car. Is there a difference between zenki and kouki lines and compressor? Or am i missing one of misc. little pieces that usually go missing causing things not to work lol.
BTW, i know the end with the 90 degree bend goes into the condensor, i just used it as an example since the fitting look the same.
BTW, i know the end with the 90 degree bend goes into the condensor, i just used it as an example since the fitting look the same.
That is definitely not an s14 ka compressor. It doesn't look anything like the one off the 98, 96, or 95 240sx's I've owned. The two fittings (high and low pressure) are always right next to each other.
Thread
Thread Starter
Forum
Replies
Last Post
HotCarl
For Sale/WTB Nissan
0
03-02-2011 10:19 AM
Garage Battle
For Sale/WTB Nissan
0
12-29-2010 10:30 AM
4DRintegraT
For Sale/WTB Honda & Acura
12
01-19-2010 05:47 PM
DrDirt
For Sale/WTB Ford, Lincoln, Mercury
0
08-07-2009 03:49 AM