z32 swap engine opinions?
 

z32 swap engine opinions?..any 1 know good shops

talk to Fever Racing, the only local Z32 I have seen in person that was swapped had an SR dropped in it. But I'm sure RBs put in them, and I wouldn't doubt the possibility of V8s like a VH or LS1... all depends on your budget man :lol:

someone put a sr in a z32? lmao

PM Sameo2 on here.

im thinking going v8 with this one maybe ls1 or lt1

The real downside to the Z32 with a small block swap, is the size of the trans tunnel opening, from the research I did a while back, they might even be smaller than the 240sx opening, and doesnt help with getting the engine far enough back in the chassis.

I think if i were doing a Z32, i'd be looking in the RB25/26 direction.

i think we kan make it fit besides there are to many 240s whit rb's

Ka-t swap?

http://i97.photobucket.com/albums/l2...annon/KA-T.jpg

Dropping an RB in place of the VQ is ALMOST as stupid as an small ass SR being swapped into a Z32.

LS1's are a NASTY swap. Not so much costly (minus what to be expected) but the mounts are totally different. It would take a TON of refurbishing to get it to fit correctly. Theres enough room though, no A/C.

A fully built twin turbo VQ will wipes its ass with an RB26. end of story.

Fully built twin turbo = 20k give or take
Converted RB26 = atleast 20k not including finding the RB that isn't SHOT and doesn't need a rebuild already.