ok, my block is stripped where my oil feed for my turbo goes. i bought a tee from jgs for my oil sending unit to supply my turbo along with a steel braided line. my question is, what would be the best way to go about blocking off the old oil feed hole? i was going to put a bolt in it and quick steel it. would the be enough?

 

That's what I'd try.

Other people have had success tapping that hole to 1/4 NPT and going from there. Shouldn't even need a drill.

 

i dont want to try anything like that just because i dont want to get any shavings on the oil

 

break out the welder.

 

im going to, the jb welder..lmao