yes. they are retartedly heavy.

 

loaded up the bikes in the back w/a cooler and other gear, took it to the park for some bike riding and picnic!

 

I bent all 4 bolts on my load level sling taking the auto KA out of the shell last month.

I pulled an auto VG30DETT out of a Z32 once with a lift that had a bad seal so it would slowly decend. That wasn't fun.

I also had to put a bare KA block in my trunk to take to orlando to sell. I thought I wasnt going to be able to walk once I got home. I think it was heavier than the Z33 6psd we put in my trunk the night we traded.

 

I think pulling auto KA's give everyone trouble..especially by yourself...in the dirt lol

 

welll, I took the trans off to replace the clutch,pressure plate,flywheel etc.

I decided to clean it while it was apart. forgot before pics but ya.

pics:
Power Scrubber 5000


shit was so caked up inside.. ugh.lol




go ahead, eat off it..

 

You polished your tranny?..

remember to replace that rear-main seal. Thats probably why you had big foots shit in it.

 

Sean, I just used wire brushes and some cans of degreaser.. no polishing. lol

Im getting f+R seal and full gasket kit, Ill take some before and after of the front main seal. shit looked so gross and caked up.

Itll look brand new once im done.

 

Swapped out wheel bearings on the coupe. Hope that will fix the hot vibration issue when coming to a stop.

On the gray car, I installed the extended stud wheel hub assembly I got. Unfortunately, it was missing a stud and had a loose/stripped one so I basically had to pirate 2 studs from the back hubs to weld in for the front. I haven't welded in a while so I'd like to thank Sean for the opportunity to do that.

I also burned out the bushings in my s14 arms and installed the Energy Suspension ones. Those will go on after I get the ball joints in.

 

sil front put on last sunday. wired up high beams and fogs tuesday. painted today and rolled out the the jdm thingy, and got some corners out there from j phat. put the corners in 2 hours ago. not to shabby for a sil front.

 

Toilet cleaner works really well for aluminum, FYI. Come and get my exhaust.