Yeah yeah yeah. On my S13 it definitely stiffened up the front.

Hey, if I can borrow your fab skills for a day we can definitely get that going.

I've also got pics of all the S15 factory braces. We should make some of those, too. Anyone have a pipe bender?

 

fixed the O2 harness I smashed when I scraped, but when up on the lift I found out my rear tires were chorded and had to do an emergency tires replacement. Once off the car I found out I have a toe in problem on the back right so I will be getting an alignment for that....

 

 

well fixed my exhaust smacking around under the car and thought i fixed my wierd clunking noise when i let off the brakes cuz my tc rod was loose but nope wierd clunking noise is still there.

 

lol a-ron try to make it on time today im moving tomorrow so everything has to be done

 

I always figured that a big front sway and fender braces would be enough. I might make up a copy brace of my own then.

I need to fab up a decent mandrel bender. There are ways to make them for about 300-400$ I usually just use a torch and bend tubing by hand though.

 

Did a little of this today:


That's top of 2nd gear, just entering, had more angle than that through the rest of the turn.

 

picture dosnt work

 

I'll reload it to photobucket then.

 

Just looked at the picture, and it looks parked, but it's just a fast exposure on the camera that was used.