i have a blacktop sr and i started installing the rev limiter tonight and everything works fine except the rev LIMITER part. the unit has power and lights up at 2500 like it says in the instructions but it just keeps reving like the unit was never installed

i used the website posted a few weeks ago but the instructions were vague. i think my problem wire is the green one or "ignition signal" wire i have no clue what pin its supposed to be on i changed it several times but every pinout i find is wrong or im an idiot i do have a safc neo installed but i made a seprate ground for the bee-r like the instructions said but idk whats wrong???

i know somebody else has wired this be4 and if you have the pin numbers that would be great.

help please!!!!

 

hey ricer! jk ill be down that way today so ill give you a call!

 

you got the cam angle wire hooked up wrong i did the same thing get an sr20 pin diagram off line and ill tell you wat goes where

 

alright here you go

GREEN- pin 22- White Wire
YELLOW- pin 31- Black Wire
RED- pin 38- Black Wire/ White Stripe
Black- pin 39- Black Wire

If the car does not start after this dont freak out switch the green and yellow wire it should crank right up. Also when switching the gain or rev if you move the dial to slow the car might shut off. And dont use it right when you crank up the car let it warm up first. Have Fun I Love Mine. If you need anymore help just Pm me. O and if you want it off just put gain to zero.

 

thanx that helped alot. i just got it working and i love it. but i did the car wont start thing and i knew i had it then lol thanx its already too much fun =)

 

ya mine did the same thing the way i have it written down up there is how its suppose to be but mine wouldnt start that way so i switched them and it worked im not whure y its like that

 

 

i thought ppl might like to see the finished product. i love this thing

 

hot damn, nice job

 

turn the gain to like 7 and the rev to like 6 and you get pretty pick flames