here it is the question everyone hates and getts all the time but ill ask it anyways i need some helpfull hints on converting my 240 (s13) into a rhd car yes its a waste of time and money but its something ive always wanted to do but could never get a clip cheap untill i bought a 240 and clips are around everywhere for them i have a very good idea of how to do it but for u guys who have done it , does everything u need come with the clip that has no motor or tranny atached to it and does my wind shield have to come out and do i need to make brake lines and what about my windshield wipper motor and help would be great and if any of u have a clip how much would u sell it for xat and cfp are out of them right know thanks for reading

 

Its pretty easy to do if you have some mechanical knowledge and fab and welding skills, and dosnt cost you any money if you buy a front clip in the first place. You dont need to take out the windshield but its alot easier to do with it out,I would personally take out the brake, clutch and fuel lines, you are going to be in and out of the car all the time, anything you can take out helps.

 

i can weld and cut and i very machanically inclined what i mean by the brakes is do u have to make new ones becus if u put the ones off the clip on wouldnt they be on the other side and how long do u think it will take to start and finish a prodject likr this and yours looks very nice

 

why didn't you convert to rhd ebrake?

 

this isnt nissan tech