Probably stupid but do you have to yank the whole motor out of 240SX to replace worn or damaged mounts? Can i just support the motor/tranny on jack stands and replace one mount at a time. Just curious.

 

no, do what you said.

 

Never mind, I did some searching on some other forums and found some good instructions. :bbb: to me for not searching, I should know better. This can be locked or deleted now.

 

Share your info for further references

 

Go to www.240sxforums.com and search for motor mounts. All the information you need.

 

Hey you can go there too and read the first thread in the forsale/wanted section on why i never got a bov for my car...its under the catback exhaust thing...

no threadjack intended

 

No problem man, this thread is done anyways.

 

you should do to your motor mounts what i did so that you don't have to deal with breaking shitty stock mounts any more. and it only cost like 5 bucks instead of 250 for nismo mounts. pm for details.

 

If I read your mind correctly your talking about using that 3M polyurethane and injecting it into the ribs of the stock mounts making them more solid. That is what I plan on doing, but my mounts are really bad. So I'm going to buy a set of cheap used 240SX mounts and "polyurethane" them up, that way they can dry for a few days while I drive my car.

...then again that was what you were refering to right?

 

yeah. it works great. solid as a rock. when your done filling them up you should put them in the oven for a bit and bake them solid. we stuck mine under some bright, hot ass work lamps for like 2 days. but man what a pain in the ass tring to get the motor mounts back in place when they don't give at all. have fun.