Ok, on my 300zx, there is a plug that goes from the power supply for the digidash, well, on this plug the engine temp wires aren't getting a good connection. I need to find a tool to remove the pins in the plug with the wires safely so I can make sure they are getting good connection. Any of you nissan gurus know what kinda tool would extract that? Pics may be forthcoming, not sure if I will have time anytime soon.

P.S. I have searched 300zx club and z31.com and nobody knows

 

take a picture, im sure that will help, i can't really understand what ur talking about.

 

Ok, i'll stealify a digi camera

 

you can usually get them out with a very small screw driver or some sort of small piece of metal that fits round the plug to push down the clip that holds it in. Can you just bend the female end to get a little better connection? Also, are you completely sure its the connector. It's very common for the connections on the powersupply components to go bad. By wiggling the wire you might actually be moving the circuit board enough to get it to make contact with the loose solder connections. Try pulling the board out and resoldering each spot real quick with a soldering iron.

 

I took apart the power supply and everything is good on the solder side. I can't move the plug by hand. and if I hold it still and just move the wires it fades in and out