haha

taylor = ricer with alot of stickers

i think you could cut down the prices on a few of those prices on a t3/t4 and the GT25r.

you guys make me want to buy a rom now

 

yea...kinda weird if ya ask me..ya'll are listed in his sig (hey you got my car done yet)

 

dave's old car.
way to bring up an old post!

 

T3T04E 50 Trim .63 a/r stg III $750 $625 for dry housing with 360* bearings, another $80 for wet bearings, still not up to 750 yet.
JGS Log manifold $400
Tial 40mm wastegate $375
Stainless downpipe $200 dont use stainless and save
Stainless dump pipe $70 not even necessary, again dont need stainless
custom intake $125 DIY for less than $50
Stainless lines $160 (fittings etc for t3t/4) these add up quick, but if its dry bearing, it will be less. even with wet bearing, this can probably be knocked down a little
reducer $20 not sure on this??
turbo gasket $20
exh mani gasket $20
z32 maf $200
tomei inj $550 $490 if u shop around
rom tune $650
t3 downpipe flange $75 $20 for a 4 bolt, $25-30 for a 5 bolt flange

some of this can obviously be knocked down, i'd think u could get away with a tial 38mm wastegate, which if u look around you might be able to get it for low $200s on sale, but i dunno if 35 or 38 will be too small and wont be able to handle it. but either or, you can save here and there.

my .02c

 

HMMMMMMM 350 Horses... By a TA.................... Just fucking with you. I'd with matt backs idea.