has anybody else had a problem with the doors on their 2g sagging? my door sags, and i cant shut the door without lifting it up a little. i tried to tighten the hinge, and ive tightened it as much as i could with hand tools, but it didnt seem to make any difference.

 

Possible weak hinge within the door? Maybe.

 

crankwalk!

 

I actually got pissed at my car for not running right once and as i was getting out, i slammed the door shut hard as fuck and bent something somewhere, and now i have to push down on the door when i close it or it wont shut right. Or if im inside the car, i have to roll the window down a hair for the door to close right. It sucks, but its my own dumbass fault.

 

im dealing with the same thing. i just grabbed my door and bent it up. you might need new hinges

 

whats worse then that is having to deal with those damn door naldes...fucking things are always breaking. i have two extra sets, just because i know they're gonna go out on me again and again. having to swap them out is even a bigger hassle.

 

Glad to see you posted this up Jason I was goona make a thread about it too. My driver door sags a little also but I dont need to lift up on it...yet. I'm pretty sure it is the pins that need to be replaced. I went to Advance just to see if they carry them and they dont, so I guess its soemthing you need to get from Mitsu-unless NAPA has them.

 

My brothers 2g does that and makes a horrible noise. Try replacing the hinges and bolts. You can always readjust it takes time but works.

 

try readjusting the hinges, takes time but works. My brothers 2g makes a horrible noise because of the sag.