What time does it start?
Last question.......

 

I think around 9:00? That's when I'm there with some of the dsm crew. But I haven't been there in like a month now.

GsEclipse02 should know, it's the meet he started.

 

i'll try to make it out there this week

 

You're giving youself a ride, homo. Your car will be fixed by tuesday night. I don't care how much money you have to put out, you're doing it and that's that.

What's the deal with yours now? Just use an easy out and get that broke bolt outta there, thread a new bolt in and you're set...

Get it done. I want to meet everybody this Tuesday.

 

If I get it all done tomorrow, I'll be there. Been busy with work and school.

 

I'll try to be there.

 

Tuesday night, Sonic on Waters? Hmm, let's see if my friend Kris and I can get his car running tomorrow- he's pulling the tranny end cap off right now to see if there is A. a viscous coupling and B. that little ball bearing because the output shaft seal started spraying tranny fluid and the output shaft was loose when we pulled the t-case. If we just need to put a ball bearing in there we should be out in his car, if not, I'll probably wait till next week and come with my car. I won't be getting the tranny back in until a few parts ship from jnztuning .

 

hell yeah same here im pretty good with cars and i can get performance parts wholesale so im always down for helping a fellow dsmer out.

 

Kris's car had no viscous coupling and a bit of metal safety wired in to hold the output shaft in place. Of course that didn't work very well as evidenced by the shaft popping out and leaking. We got a viscous coupling and a ball bearing today, but we need a snap ring and nobody had one. We'll be out tomorrow if and only if we can find a snap ring and get the tranny together with enough time for the RTV to dry. Not very likely given the apparent lack of snap rings in this town.

 

That sucks. Oh well, I'll probably be out at some point at Rj's house. I'll meet ya then.