I am gonna help goat with the 14b swap on his gsx he has the turbo. what else does he need. I have done the swap before but i cant remember what all is needed. Thanks

 

http://tampabay.dsm.org/phpBB/viewtopic.php?t=9480 this should help you out a bit.

 

i posted this before for him under his original thread, i was told this is what ya need. it sounds bout right to me


Parts needed:
14b
1g J-pipe
2g LICP
10" x 2" pipe (with beads welded at ends)
2g oil feed line (oil filter side)
1g oil feed line (turbo side)
1g or 2g drain pipe
1g or 2g water lines (bending needed)
Rubber fuel injection line
High-temp Copper/Silicone gasket maker

Total cost of install kit: $40


1. Cut the 2g LICP inbetween the two 90* bends
2. use 10" long pipe to raise LICP to the 1g J-pipe
3. cut 2g oil feed line near turbo
4. cut 1g oil feed line near the already cut 2g line
5. connect the two feed lines using fuel injection hose
6. install water lines, bend as needed
7. use gasket maker in place of mani->turbo, turbo->o2 housing, o2 housing->downpipe gaskets.

 

thanks

 

the second link within the link gets into the electrical shit.

 

hey guys, where can i find a 1G j pipe?

and not the 70$ one from RRE.

 

hmm, all i did my swap with j pipe and both oil lines. thats it. i reused all my gaskets, but thats not good so go to mitsu and spend 20$ on gaskets. everything fit fine.

 

i have all the piping taken care of now. I don't really wanna splice the fuel injeciton lines in, unless thats gonna save me a good amount of $$.

aside from that, does anyone have any of the needed parts for sale?

 

what else is needed a 1g feed line? that should be it if ya got the 14b an all the piping

 

alright, cool. Anyone have a 1g feed line for sale, or know where i can get one?

what about a banjo bolt. that was mentioned somewhere.