sorry for riding this post but i was thinking of removing the smaller honeycomb after reading an article in vfaq.com for better air flow , now if i do this will there be any probs id be facing after doing this ?

 

you might experience rough idleing on cold start ups, but once the car heats up the idle should smoothin out some, and it also supposed to lean out your car a tad lil bit, because it runs so rich from the factory...

 

My car was just runnin like shit the other day bad idle and breaking up under boost, changed the wires and plugs bada bing runin good agian beside the clutch wantin to slip.. When was the last time you changed your plugs? If your runnin pretty rich youll have carbon uild up on them and replace them...

 

also your tps sensor if it going out that will make your car idle like shit too.. Just another piece of info for to try and diagnose your problem..

 

dont know that much about the dsm's... but could it be a vacume leak? i know un even idle is caused by that

 

I'd look further into the MAS.

 

ttt

 

Hey Chris...remember that little tutorial I gave you. All your answers are in there. Didn't I mention an intake leak Also, I have a leak tester, although mine is made to install on a 14b turbo compressor inlet, so idk if it'll fit the t25.

 

idle screw

 

sup cory
yeha ill have to have you check it out
i do have a 14b so it should work right ..
when you have time you think you can check it out for me ?
thanks chris