FS/FT TD05H 16G & Injectors
Just pulled the 16G off my dsm, only reason I pulled it is because the exhaust manifold I picked up has a T4 flange and this wont fit it...switched to a precision turbo PTE HP Tech 6562 T4 turbo. Got the O2 housing, and the stock manifold....was told by the guy who had it before me that it's a ported evo 3 manifold....not too sure about that honestly. I'm going to further that statement by saying I'm not tearing the damn thing down to find out if it is ported or not...practically no play in the shaft...checked it out thoroughly...if you grab it and push and pull on it...it might move like 1/4 of a mm....if that. I wont try to scalp no one as this is a part that would just sit around in my garage getting kicked around, knocked over, and dropped until I eventually broke it and just threw it away...however...I do need a new O2 housing w/ external waste gate mount that will fit my new turbo....so if you got one laying around...I'll trade ya straight up...if not...make me an offer, if it comes close to covering the cost of getting the piece I need for my ride...I'll take it. just send me a private message on here if you're interested.
I also have some 650cc FIC fuel injectors for 4g63 engine as well...looking for a decent electronic boost controller or cash...not interested in much else.
[ATTACH=CONFIG]155874[/ATTACH][ATTACH=CONFIG]155875[/ATTACH]
I also have some 650cc FIC fuel injectors for 4g63 engine as well...looking for a decent electronic boost controller or cash...not interested in much else.
[ATTACH=CONFIG]155874[/ATTACH][ATTACH=CONFIG]155875[/ATTACH]
__________________
(Insert Facetious Quote)
(Insert Pretentious explicative)
(Insert fantasy garage)
(Insert picture of someone elses car)
(Insert Facetious Quote)
(Insert Pretentious explicative)
(Insert fantasy garage)
(Insert picture of someone elses car)
Last edited by Evol-Eagle-96; May 23, 2011 at 02:24 AM.
Thread
Thread Starter
Forum
Replies
Last Post



