fantasma

recently i bought a 1984 Mazda RX-7 GSL-SE and its hard to start..
i checked the spark plugs and they come out wet.
this is what i did:
*replaced spark plug wires
*spark plugs
*fuel injectors
*hoses
*intake gaskets...
also i checked the tps, etc.,

still hard to start and spark plugs are still getting wet. (T1, T2)

i replaced the stock ignition coils with new msd 2 ignition coils..

i can started once and drvie it..
but after sittin for a few hrs. i cant get it to start...

plz any advice will be greatly appriciated.

elcododao11@msn.com

Rx7_guy

Are your plugs even firing? What are the mods? Make sure timing is on point and the coils are hooked up properly. What plugs are u using?

fantasma

the car is completely stock.. i bought new plugs.. i believe they are firing cuz the car starts.. the plugs that im usin are NGK the leading (L) plugs are BUR7EQ and the trailing (T) BUR9EQ... the old ones it had were BR8EQ-14...

Rx7_guy

Check all vac lines and hoses

fantasma

i did.. all the vac are replaced with new ones..
i can started once.. run it.. let it sit for a few hours and then try to start again and it wont start..
idk know but i think that the pressure regulator has something to do with it..
???

fantasma

ok.. so i think i got the problem solved...
i repalaced a few stuff in the car..
*new injectors
*new vacum hoses
*new ignition coils
*new spark plugs and wires
*checked & tested all the sensors
*repalaced the antifreeze
*rebuilt the starter
and now we added a delay switch for the fuel pump..
and it seems to be workin fine so far...