$45 Dyno 3 Runs with A/F reading at
Pete Stop Motor CO.


Jan 6th
8900 49th St. N.
Pinellas Park, FL 33782
727 541 3400

 

this sounds interesting

 

how did this past saturday go? might make it to this one.

 

it went pretty good, it would have been better if we didn't have iron man race blocking our street.
we had a supra w/ 458 hp

thanks

will see you

 

good stuff. going there this friday for a dyno and final tuning to finally get some numbers. for $35 i may go again for the dyno day

 

btw can you all sleeve a block? i am eventually going to need to throw in some darton sleeves and new pistons probably in a year

 

I will try and make it. Hopefully my car will be done.

 

Yes we would be able to sleeve your block and install pistons and rods! I have 15 years as a Tech, have been a master tech for 8 years and have been doing performance work for 5 years now! Will take on any mild or wild challange! See you friday!

Thanks,
Carter

 

That is good news. I will keep that in mind when either i blow my piston ring lands (1st thing to go on the 2zz-ge in the 230whp range) or wiseco offers me a better sponsorship deal then before. Most likely it will be this time next year and then smaller pulley for more boost of course.

Just to double check, i scheduled for 11am Friday correct? I blanked out after getting off the phone about what time I said.

 

Yes its 11am. Also 230whp is about the limit for most 4 cyl cast pistons! Also the min you break a ringland you will know! Lots of smoke and slight misfire! Stop driving it right then! We can save the block! Also there is no need to sleeve the engine unless u want to make more than 450 whp! We can pin the cylinders thus stabilizing the bores! Thanks, Carter