Skunk2 Coilovers HELP
Skunk2 Coilovers HELP
So I have a set of skunk2 coil-overs on my 95 civic & I decided to adjust them about 3 weeks ago. Everything was fine and the car sat very even and all that but last night when I came home I saw that my drivers side rear was a little higher, so this morning I went out and did a measurement and it's about 1 1/4 higher then the passenger side. Now the backs are lowered as far as they will go & we have taken the tires of multiple times today & we cant seem to figure out whats wrong. Does anyone know why this is happening and how I can go by fixing this issue because I hate the fact that I might have to raise the other side of the car & not have it flush anymore. Anything will help so please I am trying to get this done today.Thanks
They are sleeve over shock coilovers?
If So, Check the bottoms of the sleeve and make sure one hasn't fallen down further over the shock more then the other.
Are you running a camber kit in the front?
Did you cut the bump stops when installing the coilovers?
How long have the coilovers been installed?
If So, Check the bottoms of the sleeve and make sure one hasn't fallen down further over the shock more then the other.
Are you running a camber kit in the front?
Did you cut the bump stops when installing the coilovers?
How long have the coilovers been installed?
Thread
Thread Starter
Forum
Replies
Last Post
BaNdItO
For Sale/WTB Honda & Acura
0
07-17-2012 01:43 PM
acura787
For Sale/WTB Honda & Acura
10
01-14-2010 03:10 PM