clutch wont disengage?
Thread Starter
i stepped on my weiner!
Joined: Oct 2002
Posts: 2,994
Likes: 0
clutch wont disengage?
anyone have this problem, its a 95 so hatch with b16 and hydro tranny, brand new clutch and PP, but i cant go from gear to gear, it grinds with the car on but the tranny feels great with the cacr off.
slave cylinder is moving almost an inch,
any help is good
slave cylinder is moving almost an inch,
any help is good
__________________
.
10.02@149.5 Bullseye Power Turbos
Top Dead Center Performance
Mobile Alabama 251 661 6067
owner/operator
www.tdcperformance.net
.
10.02@149.5 Bullseye Power Turbos
Top Dead Center Performance
Mobile Alabama 251 661 6067
owner/operator
www.tdcperformance.net
Dramatic Lemur
Joined: Feb 2001
Posts: 5,398
Likes: 0
You'll need a new slave and master cylinder... CLutch either wasn't installed right, or the flywheel wasn't resurfaced, or it wasn't allowed a proper break-in period...
The clutch may need replaced also, but it will definately need to be re-installed.
Replacing the cylinders sure is some fun shit!! Good luck.
The clutch may need replaced also, but it will definately need to be re-installed.
Replacing the cylinders sure is some fun shit!! Good luck.
__________________
"Never attribute to malice that which can be adequately explained by stupidity."
AIM: TurboedTrip
"Never attribute to malice that which can be adequately explained by stupidity."
AIM: TurboedTrip
Thread Starter
i stepped on my weiner!
Joined: Oct 2002
Posts: 2,994
Likes: 0
i think a friends dad put my 6 puck in backwards when i went to take a dump, i came back and it was all bolted up, and with a 6 puck because it has no springs, it will go on both ways. its okay V8 guys dont always pay attention
__________________
.
10.02@149.5 Bullseye Power Turbos
Top Dead Center Performance
Mobile Alabama 251 661 6067
owner/operator
www.tdcperformance.net
.
10.02@149.5 Bullseye Power Turbos
Top Dead Center Performance
Mobile Alabama 251 661 6067
owner/operator
www.tdcperformance.net
