does anyone know if the basc bolt-on's (intake, headers, cam gears) from an h23 engine fit on the h22 if i did the swap or would i need to get all new parts?

 

cam gears will fit, intake will fit, header WILL NOT fit.

 

Cam gears will not fit, exhaust manifold will not fit... intake will..
Cam gears from an H23a1 will fit B16/18, but the H22 is special and gets its own I just picked up a set of JUN cam gears for mine... dropped them off thismorning to have them powder coated as they were looking pretty rough...

-Mike

 

well im gonna get custom cat. under my h22 vtec post someone said if i get the 93-98 h22 the cat is the same but that then they changed it for like 99 or 2000. i was planning on gettin that done and then gettin a swap a little later. that will work wont it?

 

just pick up a test pipe... see them on eBay all the time for the 92+ Preludes. One difference is that the OBD-2 Preludes have two o2 sensors where as the OBD-1 Preludes only have 1 ... so the tests pipes usually have a place on the for a second o2 but my test pipe came with a bolt for the hole... think it was around $60 ...

-Mike

 

so ur sayin just wait and get the full cat till i get the swap?

 

just pick up a test pipe...

-Mike

 

ttt