bigpudge

Ok tr im back again for some advice and help first off I have a 88 ef si obd0. I finished my swap and ran fine for the first day out until it just shut off on me after a 15min drive. couldn't get it to turn back on until the motor was completely cold so I drove it back and barely made it .and now when I try to get it to turn on I have to hold on the gas for it to cut on but when I let go of the gas it just dies and keep getting engine code 5 which I know it stands for map. can someone tell me what could be the problem could be? pics could be taken if needed its my only car i need running asap

bigpudge

Bump cause I really need help any help is appreciated

custom240sx

I have you attempted to clear the code yet? Swapped out the map sensor for a known working one?

bigpudge

yes i have attempted 2 clear the code and swaped out the map sensor from my boys eg

BoostedRacerDad

What color are the three wires going to MAP?
Any vacuum leak or bad hose?

bigpudge

I knew you will come to the rescue boostedracerdad lol you had help me before I can send you pics if u want but who ever had the car before me had cut the map wires but the colors going to the map are 1)green/white 2) blue/red 3) red/green but now its giving me another code the computer blinks with 1 long pause and 7 blinks after that what could that be?

BoostedRacerDad

Pretty sure you have the TPS and Map sensor plugs backwards. I bet you are throwing code 7 and code 5. Try swapping and resetting Ecu.
When the swap was done was the two outer TPS wires swapped?

BoostedRacerDad

custom240sx

Yea I was getting to the thought of the plugs being switched but I wanted to clear the obvious first.

bigpudge

Yeah they where wrong at the first start up but was corrected but its not throwing code seven now