pr3/p30 pistons in ls?
Thread Starter
bassheadsent.net
Joined: Jul 2002
Posts: 2,281
Likes: 0
pr3/p30 pistons in ls?
are these a direct swap on ls rods in a b18b? will i have any clearance issues? everything iv read says i can jus drop em in but jus wanted to check-
__________________
http://www.bassheadsent.net/
http://www.bassheadsent.net/
engine building &amp;amp;best
Joined: May 2003
Posts: 11,971
Likes: 0
Yes they r a direct press onto ur pr4 ls rods,but go with pr3. And hope u have a something better then stock cams or u will not gain anything from doing itit
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
Thread Starter
bassheadsent.net
Joined: Jul 2002
Posts: 2,281
Likes: 0
thnx for the info. i have stock cams at the moment maybe i should hold off on installing them then-
__________________
http://www.bassheadsent.net/
http://www.bassheadsent.net/
