zc motor question--look please(crazy vtec zc build
Thread Starter
Registered User
Joined: Feb 2009
Posts: 1,848
Likes: 0
zc motor question--look please(crazy vtec zc build
new to the old school engine..
i wanna take a zc shortblock and install z6 head and make it vtec boosted.
now.
what headgasket do i use
what studs
will there be problems with oil ports meeting or not getting to the head or bottom end.
tranny do i use to fit into a civic with Zc as my bottom end
(so zc block,z6 head and what tranny
i wanna take a zc shortblock and install z6 head and make it vtec boosted.
now.
what headgasket do i use
what studs
will there be problems with oil ports meeting or not getting to the head or bottom end.
tranny do i use to fit into a civic with Zc as my bottom end
(so zc block,z6 head and what tranny
engine building &amp;amp;best
Joined: May 2003
Posts: 11,971
Likes: 0
not that i really want to help you,but im guessing you have the Expensive sohc jdm Zc motor and not the dohc right?cause if so your Z6 or Y8 had is not going to work
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
Thread Starter
Registered User
Joined: Feb 2009
Posts: 1,848
Likes: 0
So Friendly,not Sure I Will Find Out Tonight,(it Just Says Zc On It Nothing Elts,, So You Tell Me.... WAS JUST GONNA BUY ANOTHER ENGINE FOR MY BUILD BUT MINE AS WELL USE THE MOTOR I HAVE IF I COULD USE IF NOT NO BIG.
Disciple of Christ
Joined: Jun 2007
Posts: 599
Likes: 0
If your "ZC" block is DOHC then mating a SOHC VTEC head is a no go. If your "ZC" block was origianlly SOHC then it came with VTEC head from Honda. Get a Z6 head gasket and check if they allign properly. All ZC engines are compatible with D-series transmissions. Hope you work it all out!
__________________
Disciple of Christ
Joined: Jun 2007
Posts: 599
Likes: 0
It should have come VTEC from the factory, but the best test is trying to line up the head gasket. Load up the block and haul it down to the parts house, or bring your old one in and compare them. For more information, check out D-series forums or ZC forums.
__________________
