Whats up TR

so i took the whole heater core system out. and i was left with the hose that comes off the block to the heater core hook up inside the motor bay area.

what do i connect the hose to that is comeing off the block?

here are some pics:

here is the hose that is on the block. right under my Vtec Solenoid.



This is the pic of the heater connector thing.

 

just go to ace hardwear and buy a U pipe to loop the hoses together its like 1.20$

 

Hey,

well there is a hose coming off the back of the block that goes into a pipe. ill get some pics up today.

 

Here are some extra pics

this is the hose on the back of the block that was going to the tube for the Heater core



these are pics of the tube coming from the back of the block under the throttle body.

 

any suggestions?

thanks

 

BUMP.

still looking for help.

thanks

 

BUMP

can i just put the hose that is under the Vtec Solenoid on the tube under the Throttle Body?



to this tube

 

Get the rubber cap-off plugs for your size of heater hoses.
Maybe from Pep Boys/A-zone, etc.

As a general rule:
Put a cap-off plug anywhere a hose would have connected.

That U-pipe is a good idea, also. If it is the right size.

Pics are better than nothing, but sometimes it helps to see it real.
What part of town are you in?-Bob

 

IM in Ocala

 

Rats. Pretty far to go....I'm in Tampa...
I ask because I just converted my (different from yours) car over to a cold non-heated intake....heater works, gauges work...but for me to describe what I did is almost impossible.

As a general principle, all metal pipes need to be either capped off
or a hose connected to them....and with some luck there will be an even number and/or pipe sizes will be the same.

If all you did was remove the heater core, connecting heater hoses to Rang's u-pipe may be your best bet.-Bob