Im in the means of changing my dx to mpfi and i dont know how im gonna add wires at b10 and b12 because i have no pins to use,. on honda tech it says that unused pins can be taken from b2 and 11. well how do i get the pins out? thanks

 

remove clip on the plug, open the plug, and then remove it.
You can just run to a pull it yard and grab an old harness for pins if you need 'em.

 

LOL, I have aparts car that i got them off of just took me a litle bit to think of it. On another not dose anyone know where that water line hooks up to on the back, alternator side of a z6 .

 

yeah there is a clip then you use a pick to pull the pins out. watch out make sure the clip is un poped or you will fuck up the harness. or yeah basiclly go to the junk yard and ripp them out of any pre obd honda.

 

To remove the pins easily go to Radio Shack and buy a set of precision flat head screwdrivers. Cost's like $5 and I've been able to remove ecu pins from non-obd to obd2 alot easier than with a normal pick.