whats going on guys.... I am new to the whole Honda thing, kinda, and was wondering if you can put a full exhaust from a 92 Hatch eg/ to a 94 eg coupe? please let me know if someone has done that with out any modifications... i was planing on doing this tomorrow evening... Hope to hear back Jason

 

Jason,
If you did the swap on 25 April, what did you learn from that?-Bob

 

you'll have to extend it a bit hatches are alil shorter then coupes.

 

You will need to take it to a fabricator for proper fitment

Here is a 4" steel to aluminum i did for an eg coupe. Visit my shop forum for more fab work examples.



4" ground clearance

 

There are adapters at some a-parts stores that will extend pipes.
Pep Boys and NAPA have a bigger selection of diameters/sizes than others. Steel-to-steel welds more readily than metals that are not the same.

The engine flexes in the chassis and most exhaust systems that are rigid are trying to pull themselves apart. Use plenty of rubber doughnuts to allow flexibility.

I use clamps from the a-parts store instead of welds, making it easier to replace segments if they get damaged, as well as
allow some flexing.-Bob