im currently doing a wire tuck on my da and i have both the pass and driver side harness un wrapped and i noticed of all the grounds comming from the lights are running in to these white boxxes along with a few wires comming from inside the cab. if i eliminate these small boxxes and ground the blk wire to the body on a clen contact point will that work fine?

are the white boxes just a bunch of grounds that run into one good ground?

need input! THANKS!

 

Those are just a way for honda to make a bunch of grounds hook up with one bolt. You can do whatever you want with the grounds so long as they are grounded somewhere.

 

thank god! im done with the drivers side and its super clean! extended all of the light wires and working on a/c wiring a little bit longer tonight and will finish tommorow mornign before classes. the b20 should show up at 2 and will be in soon after n then i can tuck the engine harness and hook up the a/c compressor