Just wanted to know of anyone that's installed the "jdm" foglights on an EG. I don't really need the wiring done. Just the mounting. To my understanding, you can't cut too much or too little, or whatever... If anyone's done it or pretty proficient at it, HOLLUH!!

 

Iv done a few. Once you pull the bumper it is simple to understand

 

get a dremmel pull the bumper and cut away the center piece... all i tell you is,, you are going to see three little tubes around the fog light hole those ur going to use to hold ur fog light,, if you cut one it will sit crooked and look bad... and as ur cutting measure the fog light to the holes to make sure ur doing it right it took me around 1hr to do it on a brand new bumper and about 3 cutting disk cuz the angles makes them break.. good luck... oh and google is ur friend i would do some reseach...


ps when ur putting the bumper back with the fogs on its going to be a pain to put it in be patient and if you have some helping hand around use them.. (i did it alone)...

 

thanks for the help guys!

 

Thanks for helping out a fellow member....and the rest of us.
Rep for you!-Bob

 

up for my buddy somebody please help-em

 

cant help him anymore than i did, lol next thing is to go to his house and do it my self... lol...

 

i've install mine but i got jdm 4dr fogs though..lmk if u need any help...

 

Hey man! It's Andrew. I think I've talked to you on clubeg6, my name on there is SiR.

Anyway, we have a write up on the clubeg6, but to answer your question in short, just take your time and dremel away. Make sure you measure. On my spare bumper with fogs, a lot is cut out, but there are three spots that are there for screws. Obviously make sure you leave those there, because you'll be using those to screw them in. With the rest of the plastic just measure, cut and repeat. You can always cut more if it's too small, but its a lot harder to fix taking too much out.

Hope that helps.

 

If you need help, PM me

I've done a few sets in my day.