CRX b16a power adders

Reply Subscribe

Thread Tools

Dec 16, 2001 | 07:00 PM

#1 (permalink)

advan7

Thread Starter

Crazy Go Nuts!

Joined: Dec 2001

Posts: 0

Likes: 0

Hey all I was just wondering what kind of times and hp to the wheels Id be looking at w/the following setup in a b16a equipped CRX Si.

Skunk2 cams and gears Skunk2 intake manifold skunk2 proggy? already have a weapon R dragon intake and thermal cat back.

and if you have better suggestions please reply.

__________________

I use a buck to wipe my @ss, 'cause see, my sh!t is on the money.

Dec 16, 2001 | 07:13 PM

#2 (permalink)

RainmanEK

Guest

Posts: n/a

i have seen b16s make upward of 170 hp to wheels with those mods but every engine is differnt! and i would expect high to mid 13s in a crx si! i run mid 14s with stock b16 in a heavy Ek hatch!

Dec 16, 2001 | 08:39 PM

#3 (permalink)

hybridEG

Guest

Posts: n/a

save your money and get a 1.8 bottom end you will have soo much more potential and you can use your pistons and get 11.2-3 compression. bUT hay those are all pretty good mods other wise save your money get a vtec controler/hondata.

Dec 16, 2001 | 08:40 PM

#4 (permalink)

hybridEG

Guest

Posts: n/a

save your money and get a 1.8 bottom end you will have soo much more potential and you can use your pistons and get 11.2-3 compression. bUT hay those are all pretty good mods dont get a skunk 2 ecu though save your money get a vtec controler/hondata.