T-bracket not fitting b18
Registered User
Thread Starter
Join Date: Mar 2007
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
T-bracket not fitting b18
Hi, I have a B20 that I'm putting in my hatch and the rear t-bracket is not matching up? I put one bolt in and the other bolt wholes are just off by milimeters! I think the bracjets may be from an automatic, but would that make a difference? All B series crackets are suppose to be the same. I'm not sure why the T-bracket won't fit my B20. It's not SOHC! It's a DOHC B T-bracket and a B motor? ANy help, maybe auto is different? It's a gsr trans with B20 block, help me out.
Great White Hope
Join Date: Feb 2008
Posts: 1,081
Likes: 0
Received 0 Likes
on
0 Posts
are you tightening up one bolt completely then trying to put the other one in or are they both loose when you try to mount the bracket? you may have to elongate the holes but I am no expert on putting a b20 in a honda by any means. try what I first mentioned then if that does not work, wait until someone with experience chimes in 
__________________
"The richest man is not he who has the most, but he who needs the least."
"The richest man is not he who has the most, but he who needs the least."
TR "Old Skool DA" Member #28
Registered User
Thread Starter
Join Date: Mar 2007
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
It's an eg hatch!. I'm using a T-bracket off of an automatic 94+ teg. This is the first time I have ran into this problem but never my firdt swap. I just don't understand. The wholes just don't line up by a little. Also i'm not tightening then tring to match up and even if I do that it will still line up. Anyways any help on the info. if an auto. bracket is different from a 5spd one?
