cylinder head cover question
Registered User
Joined: Jan 2003
Posts: 5,450
Likes: 0
Yes, b20 valve covers fit on b18a/b cylinder heads.
__________________
Authorized Dealer & Tuner for: Hondata, eCtune, Neptune, AEM, Crome, Precision Turbo, Omni Power, Walbro, Innovate & more. Dyno Tuning Services, Ecu Chipping, Chipped Ecus, Conversion Harnesses, Widebands, Fuel Injectors, Fuel Pumps, Map Sensors & more.
For more information visit http://www.Phearable.net or call 1-888-236-9831
Authorized Dealer & Tuner for: Hondata, eCtune, Neptune, AEM, Crome, Precision Turbo, Omni Power, Walbro, Innovate & more. Dyno Tuning Services, Ecu Chipping, Chipped Ecus, Conversion Harnesses, Widebands, Fuel Injectors, Fuel Pumps, Map Sensors & more.
For more information visit http://www.Phearable.net or call 1-888-236-9831
Registered User
Joined: May 2004
Posts: 3,478
Likes: 0
it looks fine...buy a few feet of pcv hose and a t-fitting. run the hose from the i/m to the new pcv valve, and T it off down through the old pvc valve hole (between the runners 2 and 3 i think) into the catch can.
engine building &best
Joined: May 2003
Posts: 11,971
Likes: 0
if you have a preobd ls motor you dont need to do that cause your only changeing the valve cover.obd1/2 valve covers have the breather on top the valve cover you can just leave that be
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
Registered User
Joined: May 2004
Posts: 3,478
Likes: 0
mine was obd-1 (94) and it was stuck in the manifold between the runners. and had the catch can on the back of the block...obd-II motors (like the one i replaced mine with (97)) had it in the valve cover and no catch can on the block.
