ok im getting a d16z6 and transplanting it into a eg hatch non vtec... now the engine im getting is vtec and i dont know what to do with the wiring harness leave the stock one and get a vtec controller or switch the harness and ecu... im getting the complete swap but no wiring harness but i get the ecu what should i do?? and guys please be specific in options i dont get bored reading thank you...

 

if your getting complete swap and your car already has a harness then you wont need one or a vtec controller waste of money , all you have to do is wire vtec 3 wires its easy ,, it drops rite in plug up harnes wire vtec change oil done

 

ahh??? im still lost!! explain to me what wires where do i plug where? please...

 

I can pin vtec in to your body harness and in to the ecu it only will take like 30 min and if you want me to do it lmk ok pm me.
Cory@CAM-Mobile-Performance&Repair

 

Here is a link to what you need to do.
http://www.phearable.net/tech/wiring/wiring.92-95.jpg
http://www.phearable.net/tech/wiring...owerwiring.jpg

 

thank u guys u have been very helpful!! if anybody wants to add something let me know im open to opinions...

 

if its a 92 then it is already pinned for vtec. Also make sure you get the ecu with the swap. It should be a p28 on the side of it.

 

+1

 

thanks guys for all ur advice i finally got it soo this is where i dont know meets OH SHIT! so ill be asking questions thanks again take it easy...

 

pm me if you have any questions