wondering how much for a ls crankshaft balanced and blueprinted for ls/vtec?Or should i just get b18c crankshaft?Last whre should i get this done at

 

Just get it balanced. Dwons Automotive in Pinellas can do it or Eiselies in Tampa can do it. You might also want to get your rods pistons flywheel clutch and crank pulley balanced along with it.

------------------
John
<A HREF=http://www.vapor-trail.net/mydyno.html TARGET=_blank></A>
Need some time on the rollers? Click Here

 

tahnks you helped me alot though this swap.iam getting endyn rods and pre balanced spoon pistons. i figure i will only have my bottom end opened up once so might well get everything done at once.Do you have ther numbers?

 

I may be wrong but if I am John please correct me. But just because the pistons are balanced...you still have to have the whole rotating assembly balanced including the pistons. When I had my bottom end balanced. It was pistonsrodscrankcrankpulleyflywheel and clutch. Eisleys did my stuff in about 2 days and it came out great. If you live in Tampa I would reccomend them... but if your in Pinelas try DWANS.

------------------
ROCKY
TEG Widower
Hatch Builder
**see the back of that hatch??? get used to it

 

<FONT COLOR=Blue>Thats the place on columbus little tan building.......right?</FONT c>

<FONT COLOR=#a8a8a8 SIZE=1 FACE=Verdana Arial>This message has been edited by trayfoe on 01-30-2001 at 09:41 PM</font>

 

Good to hear there are some good shops in the area.

Hey Rocky your car is looking good. Saw you at the intersection up at USF last week gave you the nod. Noticed the JDM R lights and figured it was you.