I have a full msd on the car now, but want to put it back to stock (99% of the car is back to stock, working on 100%)what all do I need for the stock ign set up?? i know its a very stupid question, I just wanna make sure I dont get ripped, I am most likely going to try to trade + cash for stock.

 

what do you have thats msd?

 

whole new dizzy lol

actually the only thing you really remove when you install msd is the coil and then you switch the cap for the ext coil cap... so prolly coil, cap, and fix a couple wires and youll be goo to go

 

yup ^^^

 

If he installed the actual ignition box as well that would need to be removed also.

 

well i know that lol i was just answering what he would need AFTER all that is gone

 

You should just need the whole Dizzy w/ internals.
stock Cap, Rotor, Coil.

 

ok thats what I was thinking. so this ign box thing, the other little red thing that has a spark plug type wire going from it to teh dizzy wont be replaced, its just added stuff with the msd right

 

Correct!

The only things you'll need to install back into your distributor is the stock coil and Dizzy Cap.
Do you think you can handle the swap? I wouldn't mind helping you out if your leery about the wrench turning..

-Jeff

 

im sure I could,I just never have before do i have NO idea what id be getting into. If its just a matter of unbolt this, rebolt that I Can do it but if I need to set timing or anything other wierd stuff Id rather not do it myself