is the TPS on a ITR throttle body replaceable? My TPS is starting to go bad, and when i took off the TB to check it out i notieced their are 2 bolts holding the TPS on, but there are no heads to the bolts. If they make replacement TPS's will I have to drill the old bolts out? On the top of the bolt(visable from top of TPS), it looks like their is some kind of ring, or clip holding the TPS on.. Sorry for the long and probably confusing post, im just trying to be descriptive. TIA

 

jdm have screw's usdm dont, either mutilate ur tb or buy a new one it's up to you

 

viceGrip it off.. thats what i did.. or you can make the groves and screw it off.

 

too small to vise grip off.. i might try drilling them out

 

Take a dremel and make a rivet so you can take it off with a flathead

 

^ i will try that tomorrow. Does anyone know where i can get the TPS, i went to Advanced today and they said they dont carry it. If anyone has one forsale lmk.

 

Autoparts store dont sell them seperately neither do most people since they're a pain to get off and you shouldn't just bolt the new one on you have to test it and make sure its getting its giving correct voltage and no throttle and full throttle

You can buy a used throttle body from anywhere between $20-$150

 

its easy get a flat head and put it on their in the direction to turn loose and tap on it and they come loose

 

make the slots in the screws and loosen it. Its really easy, then call me i have like a billion tps's 352-346-5199 derek

 

+1 Put a grove in it & use a flat head or start to drill it & then once the bit starts to bite turn the drill in reverse & try to get it to start them out. I can get you some oem screws that go in the tps. They have a head on them that you break off after you tighten it down..