i got a 2001 teg and i like how 5 point harnesses feel and i was wondering if there was any way to install them withouth too much moding.

thanks in advance.

H.R.

 

All you need is seats with guides for the shoulders and a couple of bolts on the floor. My DD has 4-points, and you can even install them without taking off your factory seat belts most of the time.

 

would it mess with my passenger seat?

 

I have harnesses on both sides, the only problem I ever have is sometimes the lower two will get stuck in the door, and in the summer the bitches get hawt.

 

If you want, I can show you some pics of my set up tomorrow so you get an idea of what itll look like.

 

do u have a race seat? a roll bar at least? having a 5 point on stock integra seats is pretty pointless and can cause injuries....fyi

 

i have racing seats on both driver and passenger
no rear seat..i took it out
i only have harness on driver side...the oem seat belt on the other....
i bolt the harness directly on the the seat bracket...
turns out pretty nice and less mess....

 

Don't run a harness without a roll bar (4pt.) or at leat a dedicated harness bar. Doing any less is pointless and very dangerous.

 

You will need a floor mount harness.

 

dang...You guys really, really shouldn't bolt harness to the seat brackets, the harness should be as horizontal as possible with your shoulder, not bolted down to the floor. Rollove/car crash = your spine compressed. I would get a harness bar or a cage if i was dead set on having some stunner ass seatbelts. But then again i dont have a problem with the stock seatbelt.

My 0.02