Honda/Acura Tech Honda tech discussion.

Wiring issues

Thread Tools
 
Old Sep 6, 2006 | 10:24 AM
  #1 (permalink)  
Teggy02's Avatar
Thread Starter
Drive It Like U Stole It!
 
Joined: May 2006
Posts: 959
Likes: 0
Default Wiring issues

Im haves some qustions about hookin up a Y8 head to a B7 block as , How do you wire the Vtec correctly, anyone have any tip or suggestion as to doing this swap?

and yes i have read the write up
__________________
1989 Honda CRX SI (222,000 miles) sold
1994 Acura GSR (168,000 miles) crashed/sold
2002 Acura RSX S (127,000 miles) *Work in progress*

hero.
http://www.youtube.com/v/17XBW5OZdOM&hl=en&fs=1
Reply
Old Sep 7, 2006 | 06:36 PM
  #2 (permalink)  
skunk2racing97's Avatar
UF Mech/Aero Eng
 
Joined: Apr 2003
Posts: 1,787
Likes: 0
Default

its been a while since i did a mini-me, but from what i recall, there is the one green wire for the VTEC solenoid, the two wires for the VTEC oil pressure switch, and the knock sensor (at least that was the Y8 head on a Y7), and the three-pin to two-pin IACV (again Y8 to Y7).

just run all the wires into the cabin @ the ECU and either clip and solder or get some spares and repin the ECU plugs.
__________________

University of Florida Gators - '06 NCAA Basketball & Football - '07 NCAA Basketball
Reply
Old Sep 7, 2006 | 11:38 PM
  #3 (permalink)  
mtber's Avatar
Registered User
 
Joined: Jan 2003
Posts: 5,450
Likes: 0
Default

There are wiring diagrams/pinouts on phearable.net for you to use
__________________

Authorized Dealer & Tuner for: Hondata, eCtune, Neptune, AEM, Crome, Precision Turbo, Omni Power, Walbro, Innovate & more. Dyno Tuning Services, Ecu Chipping, Chipped Ecus, Conversion Harnesses, Widebands, Fuel Injectors, Fuel Pumps, Map Sensors & more.
For more information visit http://www.Phearable.net or call 1-888-236-9831
Reply




All times are GMT -8. The time now is 04:41 AM.