head studs
Thread Starter
window shopper
Joined: Jul 2005
Posts: 1,317
Likes: 0
head studs
ok this is a dumb question but the head stude goes on the block and the head slides down on them right? so if i have an ls block with a b16 head would i get b16 r b18 headstuds?? same question with head gasket... i got a b18 brand new headgasket with the b16 head?? this wont fit will it
__________________
engine building &best
Joined: May 2003
Posts: 11,971
Likes: 0
you use the b18a/b headgast you got.and you use b16/b18c"gsr" arp head studs.and yes you install them first into the block then slide the head onto the block
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
