how do you get those two phillips head screws out? i used an ass load of pb blaster and the right sized screw driver but they still dont wanna turn....i feel like if i turn any harder they are gonna strip.....whats the best solution?

 

Try an impact screwdriver.

 

it wont strip them?

where do i get one?

 

+1 to impact screwdriver......either that or an air hammer if you have an air compressor
you can get the impact driver at the auto parts store, i believe its less than $20. just make sure you hold it on there tight so it doest walk and beat the shit out of it. its a pain in the ass to get off. i hate those fucking screws, just leave them off when you get them off. they were put in there at the factory during assembly to hold them in place. no other cars have that shit on there, they're not needed.
good luck!

 

any auto store or sears

 

thanx

 

Just try your screwdriver, if they strip they strip. Then drill of em out.

 

any cheap ass drill, with the correct phillips bit, find the right one for the screws, usually a fatter wider point.
Press into them to make sure you them strip them. They will come out easy as hell.
Done it millions of times, well maybe not millions....hahahaha

 

Try heating them with a blowtorch if you have one. A buddy of mine took care of a frozen lugnut with his. It came off with amazing ease after that.

 

are you suposed to get your bearings or rotors that hot?