ok im got a zex wet kit. all lines ran foggers in, and got the arming switch and ground hooked up. all i need to know is which of the 3 wires on the tps do i put the white wire on the zex. if anyone know please help me

 

i think its red and yellow im not real sure on the pin strip but im for sure its the red one its the only red one in thaqt little harness i went right uder the tps but yea man its red one for sure gook luck

 

ok wired in with the red wire opens once then wont again, do you calibrate it, this is my first zex kit so im not sure how this "smart box" works

 

no you dont have to calibrate it i dont think go to zex.com for the instructions i dont remember its been along time since ive had mine hooked up

 

ok found out how to program wot. so i did. i armed teh system pushed teh black button on the side held the throttle at wot for 10 seconds. turned it off then turned it back on to give it a try. solenoids open once and wont open again. but if i put it to a staight 12v it will work all day (threw a push botton). i read somewhere that teh tps needs to put out atleast 4.5v to activate it so i guess that will be my next step

 

well i gave up on teh tps, so i was thinking how to activate it and didnt want to drill and holes.................. well long story short i wired it to my front windsheild motor because my hood squirters are shaved. keeps my hands next to the wheel and uses the same hand i shift with