Anyone know anything about the anr motor mounts for bseres? Going to be using a hydrolic tranny with the cable car. Are those conversions sold seperately? They look like mig welds kinda like place racing. There $180.00 compared to the no welds hcp mounts. I would need kit efb2 with the hydrolic adaptors. Which route should I go. AN-R's(place racing mounts or HCP?)

http://an-r.com/mounts.htm


I just bought a Longblock from Hmotorsonline.com. There 599.99 plus 300.00 shipping. Si motor. My lsvtec is a huge money pit. And really disapointed that my dseries was puttin down almost 250whp with the nitrous before it blew up again. Not looking to spend to much into this bseries b16. I will be using my gsr tranny on it though. So I need some advise on what mounts to go with. Those welds don't look like they would hold much. Look like ebay mounts.


I need to sometime in the near future replace the hf motor.

 

i dont know about the mounte specifically, but i know the rest of thier work i've seen is inexpensive, and pretty good quality. i'd use em.