Changing out rods . .
Thread Starter
Registered User
Joined: Mar 2004
Posts: 5,211
Likes: 0
Changing out rods . .
Would it be wise to just swap out the bad rod that is very slightly bent. To a new rod using the same piston resuing the same rings, and the rod bearings? You think it would work? Or do it the right way and replace the main,rod bearings, and rings? Iam really desperate for a y7 block.
engine building &best
Joined: May 2003
Posts: 11,971
Likes: 0
if thay are factorybearings then yes might as well replace them while you have it all apart give more life to the engine and no more worries
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
Thread
Thread Starter
Forum
Replies
Last Post
SILVIA-S14
Nissan/Infiniti Tech
5
Jul 28, 2003 04:10 AM
Underground Performance
Power Adders
1
Sep 24, 2002 10:36 AM
