does anyone know where i can find out what all ill need to switch over like cv axles and the like?

 

try hasport.com, they have a good site, they tell u about the axle combo u will need for the tranny u will be using, if u have a s1 tranny then u can use 90-93 teg axles....As for the whole swap it is pretty easy i think one of the esasiest swaps to be done to a honda besides a b18a....I am guessing u have a 88-91 civic or crx, if u do than it is simple, if u have multi point already and dont have a hf....If u have 88-91 civic si then basic swap get mounts, engine, tranny, half shaft, the pr3 ecu or pw0, and then run 4 new wires to the ecu, knock sensor, secondary o2 sensor, vtec selinoid, and oil pressure sender....then u will need custom shift linkage u can use yors and lengthin it, or hit up hasport.com or hcpengineering.com....If u dont have a 88-91 civic sorry for posting..thanx


-Braxton

 

my bad i see u have a del sol, just get all the del sol vtec stuff that simple..

 

if you have the money and ability i would grab the cv's, tranny, mounts, ecu, and wire harness...may be over kill but atleast you wont have to worry about anything not fitting or working