Honing Grit?
Thread Starter
Honda Guru
Joined: Jul 2003
Posts: 1,265
Likes: 0
Honing Grit?
Hey I just whent and picked up a honing tool from the local auto parts store, and it came with 300 grit honing blocks on it. Is this an ok grit to finish honing with? or should i go with a higher grit to finish it? all helps appreciated -Ben
__________________
Thread Starter
Honda Guru
Joined: Jul 2003
Posts: 1,265
Likes: 0
Too late, i got the blocks, couldnt find the other type anywhere, i put the pistons back in tonight i hope this thing runs with the 300 grit hone job, i didnt seem like they were too deep in the walls. -Ben
__________________
engine building &best
Joined: May 2003
Posts: 11,971
Likes: 0
that is a perfect grit as long as you do it up and down and dont keep it in one place
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
