ive got an EF w/a b18c1 swap and have a cracked CV . . going to replace axles. . . . what axles are used in this swap? is it a early 90's teg?

 

no you need 94+ Gsr axles does not matter if abs/or automatic just tell them you need 95 acura 1.8 dohc Vtec axles

 

even if i have a LS cable tranny?

 

90-93 teg

 

 

cool thanx guys . . for both sides right?

 

what the hell you talking about ok you go and buy a drivers side axle for your HALF SHAFT FROM A GSR and see if a 90-93 Cv axle will fit AND ALL 90-01 passanger side axles are the same so shut the hell up i no what im talking about

 

. . . .its an 1989 EF dont know if that makes any difference

i thought it was early 90's but wasnt sure . . . thanks again changing soon.

 

does not matter the wheel hubs are the same teeth,and almost the same width,but the passanger side axle you can get from any integra as for the drivers side unlike the top people that dont no to much your gsr motor as like the 99-00 si b16 it has a different halfshaft the half shaft is a small shaft that bolts to the block of your car so that you may make the cvaxle fit,and makes it more stable unlike have one 3 foot axle like Dseries...well your gsr motor has a MALE end on it unlike the 90-93 halfshaft that has a FEMALE so do the math if you buy a 90-93 cvaxle it will have a both male ends and will not fit into your 94+gsr halfshaft