the motor is just about completely broken in and i am running around on my old ls/vtec turbo hondata program from my old "tired" motor. all i did was swap out the old ls block for a sleeved 84mm ls block. i wasnt actually dynoing it but just wanted to see where the a/f sits so i know how bad it is and i dont fuck up anything before it gets tuned. i only revved it to 5500 because it went dead lean(16:1a/f). it made 225whp and 206wtq @7psi @only 5500rpm. the torque was still climbing and the horsepower was almost verticle going straght up when i let off!!! i was very pleased with my work as i did it ALL myself and for any of u who have built your own motor it makes you feel really good when everything goes well. at 7psi it looks as if it might do almost 300whp! sorry for not having a graph but i didnt have a disk with me.
setup is as follows:

B18a Golden Eagle sleeved to 84mm
eagle rods
CP pistons 9:1
ITR oil pump
B16 head
GSR cams
skunk2 valvetrain
t3/t4e 60-1 stage 3 .63ar
XS eng. 20x10x3 FMIC
revhard manifold
skunk2 IM
880cc injectors
etc.

 

Congrats, and nice work. It does feel great to do everything yourself, especially when you do everything from assembly, install, and tuning yourself. It feels even better when everything works out just right. Good luck and I'm interested in hearing the results with finished product after tuning and break in.

 

Very nice setup man..................If only my Si could make some numbers like that.

Do u work in international mall????? I see a turbo Si there alot cuz I workl at Hollister......just wonderin

 

Man, nice numbers. Can't wait to see that fully tuned. Great job

 

no but i used to about 5 months ago

 

DROOL

 

good shit dave, nice numbers hopefully mine will hold up long enough to make it to glens, that noise is geting a little louder, i will probably have the head off next week

 

Cant wait to see it Dave.

 

nice man sounds like a great new setup:o

 

so when are you and Qitstrn racing again?