i have a 96 integra ls
n i just purchased a type r front bumper hood n fenders (usdm)

but before i removerd the old one i got into alil accident.
n the hood was bent up alil n the bumper was pushed down.

The hood dosnt meet up with the bumper properly
and whem i look at the radiator support i can see it is realy bent. but my question is, is the radiator support welded on ?
i checked the price of a new 1, and its 190$
so i was woundering how to take it off.
thanks 4 the help.

 

i have no clue what support your talking about ? they all have the same support i thought, did you get the rightyear font end ?

 

nm i see what your saying i need to put my glass's on ! what support are you talking about ? like at the bottom ? where it sits in rubber supports ?

 

http://www.c-speedracing.com/howto/jdm/jdm.php


this has pictures and instructions on how to do it ! its welded !

 

I think we might have the same problem. i took got into a little accident and my hood doesnt close unless u apply pressure. I went to a body shop and the guy told me it would be around 50bucks to return the bent part to normal. Well the part thats been pushing is only about .5cm from where it should be so its not that much work. So take ur car to a body shop and get a quote, it dont think u would have to mess with anything much after

 

one more things if ur piant looks alittle bit chipped around the hood latch u dont have to necessary worry about the radiator support. just havbe ur frame straightened out and everything would be back to normal. I thought my radiator support was pushed in too. but that had nothing to do with it really