I have a freind at independent driveshaft in st.pete. There were going to rebuild me a axles so that it fits right. Right now its rubing on the strut arm on both ends. And when I turn its really bad. So even going in a straight line it still rubs slightly. Iam not sure if I should go through them or not cause they really dont know to much about swaps and what to use and not I guess. I thought I would ask here first.

Its is at right now about a 45 degree angle. Its not striaght left to right like they should be. I need some ideas cause iam not clear on this still. What axles, intermeditate shafts do you use with this setup. I have 91 integra front brakes spindles and all. What am I suppose to use. I need a simple answer. They seem like there to long but not sure. It anyone can please give me a list of what axles to use.

B16A with a S1 tranny. Integra Front brakes on a 88 CRX SI.

 

ttt

 

use integra forks that fork part that your strut goes into and bolts to the lower controll arm the integra one has about a full In. curve on it then the civic/crx cause im guessing your has to be lowered then right

 

its lowered and the forks are curved but they still rub. Its curved about half. Is there a picture of inegra forks and crx/civic forks so I can tell the differnce.